Are you still annoyed by the overflow of water from the sink?Are you still worrying about water leakage in the shower or bathroom because the threshold is not high enough?You can try to install this water guard at ​the bottom of the window sill, the gap between the grass sill, the joint and the periphery of the washstand and the wall. While solving the water leakage problem, it also beautified the decoration.Material: SiliconeWidth: 1.6cmHeight: 3cmLength: 50cm , 60cm , 70cm , 80cm , 90cm , 100cm , 110cm , 120cm , 130cm , 140cm , 150cm , 160cm , 170cm , 180cm , 190cm , 200cm , 210cm , 220cm , 230cm , 240cm , 250cm , 260cm , 270cm , 280cm , 290cm , 300cmColor: White , Pink , Grey , Blue , GreenPackage includes: 1 *Water barrier thresholdInstallation Steps:1. Clean and measureMark the position where the mark needs to be installed and cut it to the required length.2. Peel off the stickerRemove the adhesive and install the sill at the marked location.3. Fixed water damPlace the shower dam in the position where it needs to be installed. Press hard while tearing off the adhesive.4. Reinforce with glueApply glue to the joints between the two ends of the shower dam and the desktop/ground. Keep dry within 24 hours after installation.Notes:1. In order to strengthen the fixing and waterproof effect, it will be better to use glass glue to seal the bottom edge after the adhesive. Must caulk all the way around the edges or seals to avoid water leakage.（glass glue not included）2. Due to different displays and lighting effects, the actual color of the item may be slightly different from the color shown in the picture.3. Due to manual measurement, a measurement deviation of 1-3cm is allowed.